After a long absence (sorry), I am back with some updates. I needed to locate a new Clutch housing shaft for the Kalmar because the original one had been cut.
I came across a problem when this was re-assembled....The bearing I normally use, would not work. The inside diameter was too large and purchasing a proper one was too expensive (they are selling for 98,00 Euro each in Holland).
![Bild](http://lh5.googleusercontent.com/-upR5e9xUQtE/UUh01dMXRQI/AAAAAAAAc2Q/RR3WsXKum0o/s720/IMG_0089.JPG)
The inside diameter on a SKF 6305 bearing (only cost 27,00 Euro) is 25mm, the shaft is 22mm.
The solution: A 22mm to 25mm Bronze Reducing Bushing!!
![Bild](http://lh3.googleusercontent.com/-IAeU12u7s08/UUod7dFH9WI/AAAAAAAAc3M/9Nt7jldzpXc/s512/IMG_0093.JPG)
Now the new Bearing fits perfectly.
Finally I can get the Clutch assembly back on the motor...
The final bearing used is an SKF 6305-2RS1 (double rubber sealed).
98,00 Euro verses 27,00 Euro....which will you use??
Hans